Air-energy water heater installation steps

Air-energy water heater installation location

The first choice for air-energy water heater installation location: is inside the enclosed balcony. The enclosed balcony is a semi-open space that can be controlled independently. The air-energy water heater installed in this location can be used as an air conditioner in summer and a new air fan can replace air in winter. It is an excellent installation location.

Second choice for air-energy water heater installation location 1: outdoor terrace. The terraces in front of and behind the houses of large houses are also very suitable for installing air-energy water heaters, which is convenient and safe.

Second choice for air-energy water heater installation location 2: Air conditioner position. Generally, there is an air conditioner position in a house. This position can be slightly improved and is also very suitable for installing air energy. If you encounter a narrow air conditioner position that cannot be installed.

Second choice for air-energy water heater installation location 3: Small platform outside the wall, beams, and columns. Water heaters are installed at these locations, but they only need to be reinforced.

Installation location of air-energy water heater instrument

The instrument, that is, the control panel, needs to be installed nearby to avoid rain. Since the operation mode of air-energy water heaters mostly chooses the "economic mode", the control panel is rarely operated, and there is no need to install it in a very conspicuous position. It can be installed on the wall of the balcony or corridor. Since condensed water is discharged during the use of air-energy water heaters, the installation location of the air-energy water heater must have drainage facilities such as floor drains and ditches.

Test procedure after installation of air-energy water heater
First, connect the cold water pipe to the air-energy water heater. The cold water pipe is connected to the water inlet at the safety valve position. Then fill the water tank with water. Filling the water tank with water is the most important step. Filling the water tank must be completed before connecting the hot water pipe. When water flows out of the hot water outlet, it means that the water tank is full of water. Then close the valve and stop filling the water. Then connect the hot water pipe of the air-energy water heater, open the water inlet valve, plug in the power cord, start the machine, check the water pipes and wires, listen to the sound, check the fan, and observe the instrument. After running for 10 minutes without abnormality, the test is completed.